The  UMV  series   washgun 
has      been      designed  
primarily to avoid hot water waste, while  assuring very comfortable operation conditions. Its thick rubber casing not only effectively protects the operator’s hand from the discomfort of hot water but also assures an excellent protection in case the washgun is dropped or falls to the ground since it avoids any damage to the tiles or the equipment. The careful design, mainly used for the food industry, also includes a grease and detergent resistant quality rubber, plus a blue colour has been chosen as a visual aid to be seen clearly against a white or clear foreground. The trigger is lined too, and can be held in the open position by means of a lock-ring. The spray pattern can be adjusted continuously between a closed straight jet to a wide angle spray, so that the proper spray pattern can be choosen for each individual job.


Materials

Body	T2	Brass casting, chrome plated
	B3	AISI 316 Stainless steel
Lining	E0	EPDM
Stem	B3	AISI 316 Stainless steel
Trigger	B3	AISI 316 Stainless steel, rubber lined
	LT	80° C
	LP	25 bar
	LQ	21 lpm @ 3 bar UMV 2210
		61 lpm @ 3 bar UMV 2211

Hose shank	13 mm – 1/2” hose fitting
Weight	0.9 kg

The versatility of this washgun is enhanced from the additional model UMV 2211, which can be fitted with nozzles or different lances through its 1/2” female thread. The three different lance models shown are easily fitted to the gun body with a 1/2” male nipple and offer the following choices of operation:

1. Foaming machines and equipment prior to washing operations. The foam lance comes with a quick connect female coupling, and a matching coupling must be fitted at the gun outlet.

2. General purpose 1/4” fem thread outlet, 1/4” male thread inlet. Available both with heat protection sleeve, or zincplated steel.
The general purpose lance needs a connection nipple 1/4” fem to 1/2” male to be fitted on the gun. Please see the complete washgun and components codes below.